Install Ro Filter Assembly; Install Storage Tank; Install Reverse Osmosis Filter Assembly - Kenmore 625.38156 Owner's Manual

Reverse osmosis system
Table of Contents

Advertisement

INSTALL
REVERSE
OSMOSIS
FILTER
ASSEMBLY
The Reverse Osmosis Filter Assembly
is mounted
on
hanger
washers.
The hanger
washers
allow you to lift the
filter assembly
from the washers without
any hardware
removal.
When planning
your installation,
you need to
leave room for changing
filters. See Figure 11.
Complete
the following
steps to install your Reverse
Osmosis
Filter Assembly:
1. Remove the cover.
2. Locate mounting
slots on back of the assembly. See
Figure 11.
3. Hold the assembly
up to the wall surface and mark
locations
for the hanger
washers.
This allows room to
change filters.
4. Fasten the hanger
washers
to the wall using the wood
screws provided.
5. Hang assembly
on washers.
6. Replace cover.
Hanger
Washe_
(2)
::
Screw (2)
15-1/2" Minimum
up
from floor. This distance
allows
for space to
change filters
Figure 11
INSTALL
STORAGE
TANK
1. Apply thread
sealing tape to the threads
on the nipple
at the top of the tank (max. 2 wraps). See Figure 12.
2. Locate the tubing
connector. Tighten the tubing con-
nector with a wrench onto the tank nipple
7-8 turns,
being careful not to cross thread
or overtighten.
See
Figure 12
3. Do not connect the tube at this time. This will occur
later in the assembly.
4. Place the storage tank next to the Reverse Osmosis
Assembly.
The tank can be placed upright
or on its
side.
tank nipple
\
J_
/F
//
/' /
s i
tubing
connector
tank
Figure 12
Questions?
Call The Kenmore
Water Line i-800-426-9345
or visit KenmoreWater.com
li

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

625.381560Ultrafilter 450

Table of Contents