Download  Print this page

Flow Control; Change Collet And O-Ring; Change Battery - Kenmore 625.38156 Owner's Manual

Reverse osmosis system
Hide thumbs

Advertisement

Table of Contents
FLOW
CONTROL
The flow control is vital for proper
operation
of the
Reverse Osmosis
membrane
cartridge.
See Figure 26. The
flow control, located in the red tube at the system hous-
ing, keeps water flowing through
the membrane
at the
required
rate. This is to ensure
the system produces
the
best quality product
water.
Periodically
check the flow control assembly
to be sure
the small hole through
it is clean and unrestricted.
if the flow control assembly
requires
service, review
the
exploded
view in Figure 26. Assemble
and disassemble
as shown.
i
(...].
Flow Control
Insert
..... ifz
i_...._
1/4" Red Tubing
Drain
Figure 26
CHANGE
COLLET
AND
O-RING
1. Remove the collet and o-ring from the fitting with a
small screwdriver.
Be careful not to scratch the inter-
nal walls of the collet port. See Figures 27 & 28.
2. Clean collet port, lubricate
and insert the o-ring seal
into the bottom
of the port. See Figures 27 & 28.
3. Push the collet inward until it locks in place. See
Figures 27 & 28.
CHANGE
BATTERY
To change battery, complete
the following
steps.
1. Loosen the screw on the right side of the faucet base.
See Figure 29.
2. Press the battery
housing
upwards
from the front
faucet base until it releases
from the faucet base. See
Figure 29.
3. Replace the battery
(Maxell CR 2032 or equivalent).
Place battery into the holder with the positive
(+) side
facing the back of the holder.
4. When the battery is first replaced
it will flash six times
and turn off. This indicates
the battery
is fully
charged.
After the six flashes the timer enters the 6
month time cycle, if it repeatedly
flashes just two
times, it is not a fully charged
battery:
5. Re-install
the battery housing
and firmly tighten the
mounting
screw. See Figure 29.
Push o-ring seal into bottom
of
port then follow with collet.
Fitting
O-Ring Seal
Collet
Change
collet and o-ring
Collet (depress
to
remove
tubing)
Disconnect
Tubing
Battery
Bartery
negative(-)
_.__
FaBuce; _
_
Screw
Figure 27
Figure 28
Figure 29
Questions?
Call The Kenmore
Water Line 1-800-426-9345
or visit KenmoreWater.com
21

Hide quick links:

Advertisement

Table of Contents
loading

  Related Manuals for Kenmore 625.38156

This manual is also suitable for:

625.381560Ultrafilter 450