Disassembling - HIKVISION DS-2CD2712F-I Quick Operation Manual

Network Dome Camera· Quick Operation Guide
● Make sure that there is no reflective surface too close to the
camera lens. The IR light from the camera may reflect back into
the lens causing reflection.
● The foam ring around the lens must be seated flush against the
inner surface of the bubble to isolate the lens from the IR LEDS.
Fasten the dome cover to camera body so that the foam ring
and the dome cover are attached seamlessly.
2.1

Disassembling

Steps:
1. Loosen the three screws on the edge of the bubble with the screw
driver.
2. Open the bubble and remove the inner black liner as shown in
Figure 2-1.
Figure 2-1
Black Liner
Remove the Bubble and Black Liner
12
Screw Hole
Bubble