Scale Zero Push Button - Datalogic Magellan 8300 Quick Start Manual

PRESS
DURATION
Momentary Zero Scale
Momentary
(when the
scale's primary Scale power
indication shows cycle
an under zero
condition)
Scale Diag-
4 Seconds
nostics Mode
a. Diagnostics Mode is meant for use by trained systems support personnel. Users should not need to ini-
tiate this function under normal circumstances.
EAS-Enabled Systems
NOTE
6

Scale Zero Push Button

The Scale Zero Push Button is used for two functions as described in
. This button has no function on "scanner-only" models.
Table 3
Table 3. Scale Zero Push Button Functions
FUNCTION
When programmed to do so, the yellow Scale LED should be lit when no
weight is on the scale, indicating scale at zero. If it is not, press the
switch to zero the scale. The unit will sound a "click" upon pressing the
button.
When programmed to do so, and when certain conditions are met,
pressing this button will initiate a scale power cycle. When the scale zero
button is pushed and the weight on the scale is close to zero, the scale
will zero normally like the zero scale function above. Otherwise, the
scale will go through a power cycle. If the scale is able to find zero after
the power cycle, the scale will perform normally. Otherwise, the scale's
primary indication will display a non-weight indication.
This mode allows system support personnel to troubleshoot problems
a
with the scale. Cycle power to exit Scale Diagnostics Mode.
Electronic Article Surveillance (EAS) systems are aftermarket options, and
are installed by either Sensormatic
depending upon which EAS product package is purchased to use with your
scanner.
Once the system is activated, EAS security tags are automatically deactivated by
passing items over the EAS antenna located beneath the scanner's platter.
COMMENT
® ®
or Checkpoint technicians at your site
Magellan
TM
8300/8400