DFI G586OPC User Manual page 57

G586OPC
Connecting the Floppy Disk Cable
The Floppy Disk Connector on the
G586OPC System Board
Step 1
Install the 34-pin header connector into the floppy disk
connector (J8) on the system board. The colored edge of
the ribbon should be aligned to pin 1 of the J8 connec-
tor.
Step 2
Install the other 34-pin header connector(s) into the disk
drive(s) with the colored edge of the daisy chained
ribbon cable aligned to pin 1 of the drive edge
connector(s). The end-most connector should be at-
tached to the drive you want to be Drive A.
52