Advertisement
Microphone Connection
Mic1~5 inputs are unbalanced standard 6.3 Phone Jack , rear panel.
Mic1 input has VOX priority which will override Channel 3~6 and Line input signals but
NOT the Channel 2 input.
Line (Aux/CD) Connection
The equipment provides an auxiliary input which may be used for connecting other signal
sources such as a Radio Tuner, CD or Cassette player. A slide switch is located on the read panel
for selection of, Channel 4 Mic4→Aux 1 , Channel 5 Aux 2 , Aux3.
The line level Control operates on each of the input sources.
To operate select the desired music source using the slide switch and turn the "Channel" control
clockwise to increase the volume or anticlockwise to reduce the volume.
The Aux / input sockets are standard 6.3 Phone Jack, single sockets are supplied and these are
linked together internally, this allows stereo signal source to be used without the need to obtain
a special lead, however you may wish to check with the manufacturer of the signal source to
ensure that no damage will result if the left and right output channels are put in parallel.
Tape output Connection
These standard 6.3 Phone Jack sockets provide a mixed output suitable for connection to
a tape or Cassette recorder.
Aux out
Connects the mixer/preamplifier stage to the power amplifier stage. The connecting link must be
plugged in for normal operation as a mixer/amplifier. "AUX OUT" is after the tone controls and
the master volume control.
Power outline voltage comply with power input voltage (IEC voltage).
Loudspeaker Connection
Note: Use only 100V or 70V (Selectable) Line Loudspeakers
Low Impedance (8 )
This output allows connection of standard low impedance loudspeakers, the minimum load
impedance must be 8 , when to or more loudspeakers are use ensure that they are wired in
such a way that the load impedance is between 16 or between (4 ).
Connecting a Mixer Amplifier to a Power Amplifier
These amplifier can be connected using phono to phono leads from the mixer amplifier PRE out
the power amplifier input RCA socket. Further power amplifier can be connected by connecting
from the output of first power amplifier to the input of the second. Up to three power amplifier
can be connected in this way.
Input must be from power amp in (Rear Panel) (Mic1 XLR Jack)
(4)
Advertisement
