General - Kenwood TK-3230 Service Manual

TK-3230
Document Copyrights
Copyright 2007 by Kenwood Corporation. All rights
reserved.
No part of this manual may be reproduced, translated,
distributed, or transmitted in any form or by any means,
electronic, mechanical, photocopying, recording, or
otherwise, for any purpose without the prior written
permission of Kenwood.
INTRODUCTION
SCOPE OF THIS MANUAL
This manual is intended for use by experienced tech ni -
cians familiar with similar types of commercial grade
com mu ni ca tions equipment. It contains all required service
in for ma tion for the equipment and is current as of the
publication date. Changes which may occur after publication
are covered by either Service Bulletins or Manual Revisions.
These are is sued as required.
ORDERING REPLACEMENT PARTS
When ordering replacement parts or equipment in for ma-
tion, the full part identifi cation number should be in clud ed.
This applies to all parts : components, kits, or chassis. If
the part number is not known, include the chassis or kit
number of which it is a part, and a suffi cient description of
the re quired component for proper identifi cation.
PERSONAL SAFETY
The following precautions are recommended for personal
safety:
• DO NOT transmit until all RF connectors are verified
se cure and any open connectors are properly terminated.
• SHUT OFF and DO NOT operate this equipment near
elec tri cal blasting caps or in an explosive atmosphere.
• This equipment should be serviced by a qualifi ed tech ni -
cian only.
SERVICE
This transceiver is designed for easy servicing. Refer
to the sche mat ic diagrams, printed circuit board views, and
align ment procedures contained within.
2
Disclaimer
While every precaution has been taken in the preparation
of this manual, Kenwood assumes no responsibility for
errors or omissions. Neither is any liability assumed for
damages resulting from the use of the information contained
herein. Kenwood reserves the right to make changes to any
products herein at any time for improvement purposes.

GENERAL

UHF Frequency Selection Table
Channel
Frequency (MHz)
setup No.
01
02
03
04
05
06
07
08
09
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
User can select channel frequency from above.
Channel
Frequency (MHz)
setup No.
464.50000 29
464.55000 30
467.76250 31
467.81250 32
467.85000 33
467.87500 34
467.90000 35
467.92500 36
461.03750 37
461.06250 38
461.08750 39
461.11250 40
461.13750 41
461.16250 42
461.18750 43
461.21250 44
461.23750 45
461.26250 46
461.28750 47
461.31250 48
461.33750 49
461.36250 50
462.76250 51
462.78750 52
462.81250 53
462.83750 54
462.86250 55
462.88750 56
462.91250
464.48750
464.51250
464.53750
464.56250
466.03750
466.06250
466.08750
466.11250
466.13750
466.16250
466.18750
466.21250
466.23750
466.26250
466.28750
466.31250
466.33750
466.36250
467.78750
467.83750
467.86250
467.88750
467.91250
469.48750
469.51250
469.53750
469.56250