Kenwood TK-3230 Service Manual page 3

2 Channels (Default)
Channel Receive frequency
No. (MHz)
1 (02) 464.55000
2 (08) 467.92500
All channel are Narrow bandwidth, RF power output 1.5W with
QT67.0Hz encode/decode.
16 Channels (Default)
Channel Receive frequency
No. (MHz)
1 (02) 464.55000
2 (08) 467.92500
3 (09) 461.03750
4 (10) 461.06250
5 (11) 461.08750
6 (12) 461.11250
7 (13) 461.13750
8 (14) 461.16250
9 (01) 464.50000
10 (03) 467.76250
11 (04) 467.81250
12 (05) 467.85000
13 (06) 467.87500
14 (07) 467.90000
15 (15) 461.18750
16 (16) 461.21250
All channel are Narrow bandwidth, RF power output 1.5W with
QT67.0Hz encode/decode.
GENERAL / REALIGNMENT
Transmit frequency
(MHz)
(02) 464.55000
(08) 467.92500
Transmit frequency
(MHz)
(02) 464.55000
(08) 467.92500
(09) 461.03750
(10) 461.06250
(11) 461.08750
(12) 461.11250
(13) 461.13750
(14) 461.16250
(01) 464.50000
(03) 467.76250
(04) 467.81250
(05) 467.85000
(06) 467.87500
(07) 467.90000
(15) 461.18750
(16) 461.21250
1. Getting Acquainted
q PTT (Push to Talk) switch
Press and hold, then speak into the speaker area to
transmit.
w MENU key
Press to perform various functions. Press and hold while
switching the power ON to enter Setting Mode.
e CAL key
Press before making a call to alert the other party
members, or press to select a unit ID to make a call
r
/ keys
Press to change the operating channel, to select a menu
in Setting Mode, and to perform other functions.
t Power switch/Volume control
Turn clockwise to switch the power ON and counter-
clockwise to switch the power OFF. Rotate to adjust the
volume.
y MON key
Press to monitor the current channel for activity.
u LED Indicator
Indicates the transceiver status.
i SP/MIC jacks
Lift the covers and insert the accessory's plugs here.
Antenna
Microphone
2. PC Mode
2-1. Preface
The transceiver is programmed by using a personal com-
puter, a programming interface (KPG-22/22A, USB adapter
(KCT-53U)) and programming software (KPG-108D).
The programming software can be used with an IBM PC
or compatible. Figure 1 shows the setup of an IBM PC for
programming.
2-2. Connection Procedure
1. Connect the transistor to the personal computer with
the interface cable and USB adapter (when the interface
cable is KPG-22A, the KCT-53U can be used.).
TK-3230
Speaker
3