Assistance Stages; Braking Mode; Regenerative Braking; Boost Mode - Riding Speed Switch - Stromer ST2 User Manual

Assistance stages

Braking mode

Using the controller on the handlebar, you can As soon as you press the brake, the motor assis-
press the control buttons + and – to change be- tance is interrupted. The motor changes to brak-
tween the following assistance modes: ing mode and supports you during braking. In
braking mode, part of the released energy is used
No-assistance mode: The motor is switched off. to charge the battery.
Assistance mode 1: Low motor assistance,

Regenerative braking

optimized for extended range.
The ST2 offers braking assistance for longer de-
Assistance mode 2: Medium motor assistance
scents. For this, press and hold the minus control
– this assistance mode can be fine-tuned using
button for 2 seconds. Briefly press the plus or mi-
the Stromer app.
nus control button to adapt the braking power of
Assistance mode 3: High motor assistance
your ST2. To end regenerative braking, press and
for maximum speed.
hold the + or - control button again for 2 seconds.
Boost mode –
riding speed switch
The ST2 provides you with complete assistance at
the press of a button. The boost mode accelerates
you to 20 km/h or 12 mph, even without pedaling.
To activate the boost mode, press and hold the
plus control button on the handlebar. The boost
mode is activated after 2 seconds. BOOST is dis-
played on the touchscreen. As soon as you release
the plus control button, the boost mode is deac-
tivated again.
i
On the screen, the selected assistance
mode is marked. If assistance mode 1/2/3 are not
marked, you are in no-assistance mode and have
no motor assistance.
6 | 7
!
The boost mode does not switch on until
you have reached a minimum speed. As soon as
you release the plus control button or press the
brake, the boost mode is switched off.
Move mode – push assistance
Your ST2 has an installed push assistance. The
move mode supports you when you wish to push
your ST2.
1. Press the power button to access the shortcut
screen.
2. In the shortcut screen, select MOVE.

Ride screen

As soon as you take off with the ST2, the touch-
screen automatically changes to the ride screen.
On the ride screen, the speed and information
about your ride are displayed for you. By pressing
the touchscreen, you can change from one ride
screen to the next to choose what ride data you
wish to see.
3. Press and hold the plus control button on the
handlebar for as long as you require the push
assistance.
i
The menu and settings are not accessible
4. Press the power button to deactivate the move
while riding. If you wish to make changes to the
mode.
settings, the ST2 must be stationary.

Light

To switch the headlight on and off, press the light
control button on the controller on the handlebar.
For your safety in daily traffic, a daytime light is
integrated in your ST2. If the daytime light is
activated (see Daytime light, page 13), it lights up
as soon as the ST2 is switched on. Upon switching
on the headlight, the daytime light is dimmed so
that oncoming vehicles are not blinded.
i
The daytime light is not legally permitted in
certain countries and therefore cannot be activat-
ed there.