Time And Status Display - Kenmore 796.4027 Series Use And Care Manual

TIME AND STATUS DISPLAY
The time and status display shows the estimated time remaining, cycle progress, and door lock status.
iiiii ii ii i!ii!ii!i ii!iiiiii!
ijjii!ii!!!!!ii i!i!!ili!
iiiiiiiiiiiiiiiiiiiiiii!iiiii!i iiii!i!ili!ii!iiii
iiiiiiiiiiiiiiiiiiiiiiiiiii, iiiiiiii ii ii ili
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii !_;!
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii ii_ii
O
ESTIMATED TIME REMAINING
When the STARTJPAUSE is pressed, the washer
automatically detects the wash load (weight) and
optimizes the washing time, based on the selected cycle
and options. The display will then indicate the estimated
time remaining for the selected wash cycle.
NOTE:
•The time shown is estimated, For example, the time
displayed may pause for a period of time while the
machine is heating the water or balancing the load.
Under certain _nditions, the machine can pause for
extended periods of time.
• Estimated time is based on normal operating conditions.
Several external factors (load size, room temperature,
incoming water temperature, etc,) also affect the length
of estimated time ve. actual time,
O LOAD-SENSING INDICATOR
This light will illuminate at the beginning of the cycle while
the _ntrol measures the size of the load. Once the size
has been determined, the control will adjust the cycle for
optimum performance. Estimated time remaining will not
be displayed until the load size has been determined and
may be different for each load,
CYCLE STATUS INDICATOR
These status LEDs illuminate to indicate which portionof
the cycle is currently running. A blinking light indicates the
active portion of the cycle. When that portion is complete,
the light will remain steady.
DOOR LOCK INDICATOR
Indicates that the door is locked. The washer door will lock
while the washer is operating. The door can be unlocked
by pressingthe START/PAUSE to pause the washer.
NOTE:
• If the temperature in the washer is too high, the door
cannot be unlocked until the washer has cooled.
, If the water level is too high, the door will not unlock. To
drain the water, cycle the power off/on, then press the
spin speed button without selecting a cycle. Press start
and the water will be drained and the clothes will be
spun out. Do not try to force the door open, as it wiil
damage the door.
18