Figures Figure 1: RC-7RL Front Panel Figure 2: RC-7RLE Front Panel Figure 3: Side Panel of the RC-7RL and RC-7RLE (Enlarged View) Figure 4: Side Panel of the RC-7RL and RC-7RLE Figure 5: RC-7RLE (Front Perspective) Figure 6: RC-7RLE (Rear Perspective)
IR learner 5 By authorized Kramer technical personnel or by an external system integrator (refer to the separate online guide) 6 That provides information about how to set up the system. This online guide may well be updated on a regular basis. For...
A/V equipment in any multimedia room, especially the control of a projector or other display device, via RS-232 and/or IR emitter cable. The RC-7RL / RC-7RLE is 12V DC fed. The RC-7RL is a one-gang wall plate. The RC-7RLE is two-gang wall plate intended for the European market.
2 These screws should not be removed during or after mounting 3 Via the front panel, without having to remove the RC-7RLE from its mounting 4 Letting you configure the RC-7RL directly from the remote transmitter without the need for software...
Your RC-7RL / RC-7RLE Table 2: RC-7RLE Front Panel Feature Function VOLUME Button Press to lower the volume on the power amplifier Faceplate Attachment For attaching the faceplate to Holes (2) the controller VOLUME Button Press to raise the volume on...
Your RC-7RL / RC-7RLE 4.3 Defining the RC-7RL / RC-7RLE Side Panel Figure 3 illustrates an enlarged view of the side panel of the RC-7RL and RC-7RLE: Figure 3: Side Panel of the RC-7RL and RC-7RLE (Enlarged View) Figure 4 defines the side panel of the RC-7RL and RC-7RLE. For an...
Each source—the PC, DVD and VCR—connects to the dedicated video and audio inputs of the projector: 1 From this section on, all the information is relevant to both the RC-7RLE and the RC-7RL, unless noted otherwise...
DVD inside, all controlled via the RC-7RLE. The presenter’s laptop is located on the podium, next to the RC-7RLE. It is also controlled by the RC-7RLE and is used for presentations and slide shows. KRAMER: SIMPLE CREATIVE TECHNOLOGY...
Using Your Media / Room Controller Figure 7: Example of a Typical Setup in the Lecture Auditorium 5.1 Operating the RC-7RL / RC-7RLE In the example defined in Table 3, the buttons—ON, OFF, PC, DVD and VCR—are programmed by the system integrator to perform several tasks...
5.3 An Example of Operating the RC-7RL / RC-7RLE Figure 8 shows an example of how to operate the RC-7RL / RC-7RLE: Figure 8: RC-7RL / RC-7RLE Operation Example 1 The macro sequence can be carried out instantly or can take a while, depending on the delay times included in the sequence...
RC-7RLE: 15.1cm x 4.4cm x 8.6cm (5.94" x 1.75" x 3.39", W, D, H) WEIGHT: 0.3 kg (0.67 lbs.) approx ACCESSORIES: Power supply, Windows®-based Kramer control and configuration software, Config. cable OPTIONS: Dual IR emitter cable, single IR emitter cable, IR extension cable, CONFIG.
Page 15
For the latest information on our products and a list of Kramer distributors, visit our Web site: www.kramerelectronics.com, where updates to this user manual may be found. We welcome your questions, comments and feedback. Safety Warning: Disconnect the unit from the power supply before opening/servicing.
Need help?
Do you have a question about the RC-7RL and is the answer not in the manual?
Questions and answers