Product Features; Code Approval - MHSC CDVR33 Installation And Operating Instructions Manual

pRODuCT FEATuRES and CODE AppROVAl
pRODuCT SpECIFICATIONS
• This appliance has been certified for use with either natural or propane gas. See appropriate data plates.
• This appliance is not for use with solid fuels.
• The appliance is approved for bedroom or bedsitting room installations.
• The appliance must be installed in accordance with local codes if any. If none exist use the current installation
code. ANSI Z223.1/NFPA 54 in the USA, CSA B149 in Canada.
• This appliance is mobile home approved.
• The appliance must be properly connected to a venting system.
• The appliance is not approved for closet installations.
• This appliance is approved to be vented with Simpson-Duravent and Selkirk-Metalbestos Direct Vent Com-
ponents.
NOTE: For illustration purposes only, all drawings show the Simpson-Duravent System.
Remote Control

CODE AppROVAl

Direct Vent type appliances draw all combustion air from outside of the dwelling through the vent pipe.
These appliances have been tested by CSA and found to comply with the established standards for DIRECT
VENT GAS FIREPLACE HEATERS in the USA and Canada as follows:
A manufactured home (USA only) or mobile home OEM installation must conform with the Manufactured Home
Construction and Safety Standard, Title 24 CFR, part 3280, or when such a standard is not applicable, the
Standard for Manufactured Home Installations, ANSI/NCSBCS A225.1, or Standard for Gas Equipped
Recreational Vehicles and Mobile Housing, CSA Z240.4.
69D0023
Hi/Lo Knob
Off/Pilot/On Knob
Ignitor
On/Off/RS Switch
Figure 1 - CDVR Series and CDVT Series Fireplace
lISTED VENTED GAS FIREplACE hEATER
TESTED TO: ANSI Z21.88/CSA 2.33 STANDARDS
Blower Control
CDV Series Gas Fireplace
5