Electronic Pilot Ignition Wiring; Remote Wall Switch - MHSC CDVR33 Installation And Operating Instructions Manual

ElECTRICAl INSTAllATION

ElECTRONIC pIlOT IGNITION WIRING

Do not connect 110-120 VAC to the
Remote Wall Switch. The appliance
will malfunction.
Ignition Module (Synetek)
15' Wall Switch Wire
BLACK
WHITE

REMOTE WAll SWITCh

Position the wall switch. Do not extend beyond
the 15 feet of wire.
OpTIONAl DC REMOTE SySTEMS
See section entitled Hearth Mount in the Millivolt
hand held remote instructions supplied with the
remote.
1. Using a flat head screw driver, bend the
"remote" tabs up from the bottom of the
fireplace. Figure 45
2. Follow the instructions on remote control to
snap the remote cover plate to the remote
receiver
3. Connect the wire terminal from the remote
receiver. This replaces the 15' wall switch
connection to the switch. Figure 44
4. Use the screws that came with the remote
control to mount the remote receiver cover
to the bent up "remote" tabs. Figure 45
69D0023
Electronic Valve
HI
WHITE #3
EV1
Figure 44 - Remote Wall Switch Wiring Diagram
"Remote" Tabs
Pilot Assembly
Spark
Sense
MAGENTA #5
GRAY #7
EV2
RS
OFF
ON
Remote Control
Figure 45 - Remote Control Location
CDV Series Gas Fireplace
To Junction Box
GREEN
WHITE
BLACK
BLACK
WHITE
Primary - 120V
Transformer
Secondary
BLUE
YELLOW
BLUE #1
YELLOW
24V
33