JVC UX-G6 Service Manual page 39

UX-G6/FS-G6
Removing the loading mechanism board/
Dolby board (See Fig.9)
• Prior to performing the following procedure,
remove the top cover and the rear panel.
1. Disconnect the harness from the connector on
the motor board in the cassette mechanism.
Then disconnect the loading mechanism board
from connector CN634 on the main board.
2. Disconnect the Dolby board from connector
CN632 and CN636 on the main board.
Removing the main board (See Fig.10)
• Prior to performing the following procedure,
remove the top cover, the rear panel, the loading
mechanism board and the Dolby board.
1. Disconnect the card wire from connector CN637
and CN647 on the main board. Then disconnect
the harness from CN635.
2. Remove the four screws G attaching the main
board.
Removing the front board (See Fig.11)
• Prior to performing the following procedure,
remove the top cover and the front panel assem-
bly.
1. Remove the seven screws H attaching the front
board in the front panel assembly.
2-34
Loading mechanism
board
CN634
G
CN647
CN637
G
Main board
Fig. 10
Front panel assembly
H
Fig. 11
Connector on the
motor board
CN632
Dolby board
Main board
CN636
Fig. 9
CN635
G
H
Front board
H