JVC UX-G6 Service Manual page 40

<<Cassette Mechanism Section>>
Detaching the cassette loading
mechanism (Fig. 1 to 3)
1. Turn the loading drive gear in the direction shown by
the arrow so that the head relay board can be re-
moved.
2. Remove the screw A securing the head relay board
(to protect the head wire).
3. Remove the two screws B securing the capstan motor
bracket.
4. Remove the screw D securing the cassette stabilizer,
and detach the stabilizer by pressing it from the side
the securing screw is on.
5. Remove the two screws E securing the bracket.
6. Disconnect the capstan motor wiring and detach the
cassette mechanism and capstan motor bracket from
the loading section.
7. Turn the unit over and remove the four screws C
securing the cassette mechanism assembly.
8. Loading section
Detach the left and right side brackets by pressing their
bottoms into the unit and then pulling them towards the
back. Detach the left side by turning the loading gear.
9. To detach the tray without removing the screws
(D and E) securing the bracket, open the stopper's
pawl as shown in the figure and release the stopper to
pull out the tray.
Turn the gear
to detach the tray.
(When D and E are not removed)
Release this stopper.
(When D and E are not removed)
Release this stopper.
E
B
B
A
Fig. 1
Capstan belt
C
C
Stopper
Push to the inside to remove.
Fig. 3
UX-G6/FS-G6
Loading gear
E
D
Loading pulley
Loading belt
C
Tray
C
Fig. 2
Open to the outside.
2-35