JVC UX-G6 Service Manual page 38

Removing the rear panel
• Prior to performing the following procedure,
remove the top cover.
1. Remove the three screws E attaching the rear
panel on the back of the body and release the
two joints "c" on both sides while moving the rear
panel upward
2. Disconnect the harness from connector CN633
on the main board.
(When disconnecting the harness from the rear
panel, unhook the upper and lower four hooks of
the wire stopper on the back of the rear panel
and pull out the harness outward.)
Removing the cassette mechanism
• Prior to performing the following procedure,
remove the top cover and the front assembly.
1. Disconnect the card wire from connector CN647
and the harness from CN635 on the main board
respectively.
2. Disconnect the harness from the connector on
the motor board in the cassette mechanism
assembly.
3. Remove the four screws F and detach the
cassette mechanism assembly upward.
(See Fig.6 and 7)
assembly (See Fig.8)
E
Joint c
E
Fig. 6
Rear panel
Wire stopper
CN633
Fig. 7 Fig. 7 Fig. 7
CAUTION: Lift the lock and
CN633
Fig.7-1
Cassette mechanism assembly
F
CN647
Main board
Fig. 8
UX-G6/FS-G6
Rear panel
Joint c
Main board
pull out the wire.
F
Connector on the
motor board
F
CN635
2-33