Replace Intelli-Time Battery - ACU-RITE 00828BPDI Instruction Manual

Calibrate Barometric Pressure
The weather station default pressure mode is "AUTO". In auto mode, the
pressure will calibrate itself over a 14 day Learning Mode. Barometric pressure
can be manually calibrated:
1. Press AND HOLD the " " button for at least 10 seconds to enter manual
pressure mode.
2. The un-calibrated pressure will be displayed. Press AND HOLD the " ",
" ", and "
3. Press the " " or " " buttons to calibrate the pressure higher or lower.
4. Press the " " button to confirm the calibration adjustment. Note: The "
icon will remain illuminated next to the calibrated value.
After 20 seconds of inactivity, the display will save your adjustments and exit
calibration mode. Note: Calibration will be erased if the display is reset or if
batteries are removed.
To exit manual pressure mode and return to auto mode press and hold the
" " button for at least 10 seconds.

Replace Intelli-Time Battery

This device comes with a factory
installed "CR2032" coin-cell battery
that powers the Intelli-Time memory.
If the display unit sits without power
for a long period of time, the coin-
cell battery may need to be replaced
to ensure the Intelli-Time feature
functions properly.
To replace the battery, remove small
screw to gain access to the Intelli-Time
battery compartment. Install battery
with "+" positive terminal facing
OUT.
" buttons for at least 5 seconds.
11
"
CR2032
3V