Pioneer DV-696AV-s Operating Instructions Manual page 6

HDMI output with DVD-Audio sources
m 6 ページ ２００６年４月１８日 火曜日 午後３時４１分
DVD-Audio sources often have high sample rates (such as 192kHz/24bit/2 channel or 96kHz/24bit/
6 channel) and the way they are output from the HDMI terminal will depend on the specification
of the connected component.
Component specification
you start
DVD-Audio and
5.1 channel compatible on HDMI
DVD-Audio and
2 channel compatible on HDMI
aving design
Incompatible with
r-off function switches the player
DVD-Audio on HDMI
not used for about 30 minutes.
1
This unit checks the specification of the connected component (such sample rate / multi-
*
channel limitations and CPPM compatibility) and outputs the signal accordingly. Note that 'DVD
ured under license from Dolby
Audio compatible' indicates compatibility with CPPM (Content Protection for Pre-recorded
Dolby" and the double-D symbol
Media).
s of Dolby Laboratories.
2
If HDMI Audio setting (page 39) is set to LPCM (2 CH) , multichannel sources will be downmixed
*
"DTS Digital Surround" are
to stereo. (In cases where the source is downmix-prohibited, only the front left/right channels are
emarks of Digital Theater
output.)
If the video output resolution is 480i, 576i, 480p or 576p, audio output may be limited to 2 channel
HDMI logo and High-Definition
(depending to the connected component).
terface are trademarks or
3
In cases where the source is downmix-prohibited, only the front left/right channels are output.
*
emarks of HDMI licensing LLC.
4
If CPPM shows in the front panel display, it means it is not possible to output CPPM copycon-
*
ssible to output SACD sources
trolled DVD-Audio sources from the HDMI connection. Discs with no CPPM protection are limited
I connection of this player.
to 2 channel output.
Ultra Certified, and associated
marks of DivX, Inc. and are used
the box
m that the following accessories
when you open it.
ontrol
ry cell batteries x 2
eo cable (red/white/yellow plugs)
ble
48
instructions x 1
card
Downloaded From Disc-Player.com Pioneer Manuals
En
Example
Component
VSX-AX4AVi-s
VSX-AX2AV-s
*1
PDP-506HDE/FDE
PDP-436XDE/FDE
*1
Putting the batteries in the remote
PDP-505XDE/HDE
*1
• Open the battery compartment cover
and insert the batteries as shown.
Use two AA/R6P batteries and follow the
indications ( , ) inside the compartment.
Close the cover when you're finished.
Important
Incorrect use of batteries can result in hazards
such as leakage and bursting. Please observe
the following:
• Don't mix new and old batteries together.
• Don't use different kinds of battery
together—although they may look similar,
different batteries may have different
voltages.
• Make sure that the plus and minus ends of
each battery match the indications in the
battery compartment.
• Remove batteries from equipment that
isn't going to be used for a month or more.
• When disposing of used batteries, please
comply with governmental regulations or
environmental public instruction's rules
that apply in your country or area.
• Do not use or store batteries in direct
sunlight or other excessively hot place,
such as inside a car or near a heater. This
can cause batteries to leak, overheat,
Disc Format
2 ch 5.1 ch
2 ch 5.1 ch
Left/Right or
2 ch
2 ch downmix
No sound *4 No sound
*2
*3
*4