Table of Contents
Advertisement
Component Information
The following is a list of other components and their
functions.
Igniter
The Warmland PS45 stove comes equipped with an automatic
igniter for lighting the fuel when the stove is in the lighting mode.
The igniter superheats air that is pulled through the Burn-Pot
by the combustion blower to light the fuel. The igniter remains
energized for the fi rst 10 minutes of the lighting sequence.
Vacuum Switch
The stove has a Vacuum Switch, located on the right rear hopper
leg. If the pressure drops in the fi rebox due to a leak, a blocked
fl ue, open front door or unsealed ashdrawer, the vacuum switch
will sense this and open the circuit to the Auger Motor. The stove
will then go into a shutdown mode.
Auger and Auger Motor
A 1 rpm gearmotor turns the Auger, lifting pellets up the
augertube. The pellets are then dropped down a tube and into
the burn-pot. The auger is controlled by the control board.
HIGH LIMIT Snap Switch (Manual Reset)
This switch is installed on the convection blower duct and shuts
the stove down if it senses excessive temperatures (Opens
at 200° F). This snap switch has a reset button on it and will
not allow the stove to start up until the reset button has been
pushed.
Proof of Fire Snap Switch
This switch is installed on the combustion blower and is used to
sense when there is a fi re in the stove during Start-Up. It will shut
the stove off if it senses there is no fi re in the Fire-Pot Liner.
Draft Damper
The Warmland PS45 Classic stove has a draft damper located
at the left side of the stove directly in front of the combustion
blower. After the stove is installed the Draft Damper will need
to be set for the vent confi guration. With the stove hot, use a
magnehelic gauge to adjust the slider until a reading of .15" is
achieved in the fi rebox. The sampling hole is located in the top
of the ash box, above the ashpan. To reduce the draft, move
the adjuster toward the center of the stove.
Burn-Pot Mixer Motor
This 1 RPM gear motor turns the Burn-Pot Mixer rod via a
coupling and chain drive system.
The Mixer Motor is controlled by the control board.
.
PELLET STOVES
Hopper Switch
The hopper switch is located on the back of the hopper. It is
activated by the arms of the hopper lid. If the hopper is left open
it will cut power to the auger motor, the fi re will go out and the
stove will go into shutdown mode. The #3, head output light
will also be fl ashing.
Fig. #20
CLOSED
18
OPEN
DAMPER: FACTORY
SET, FLUSH WITH
FIREBOX SIDE.
PS45 CLASSIC 151211-24
Hide quick links:
Advertisement
Table of Contents
