Cleaning The Combustion Blower; Cleaning The Convection Blower; Door Removal; Back Grill Removal - Warmland PS45 Classic Series A Installation And Operating Instructions Manual

Cleaning the Combustion Blower:

To clean the combustion blower, unplug the stove, remove
the left cabinet side. Loosen but do not remove the six screws
(Fig.#18) with an 1/4" nut driver or socket. Rotate the motor
counter-clockwise. The motor can now be pulled from the fan
housing. The cooling fan and main blade can be vacuumed
once the motor is removed. Before reinstalling, vacuum out the
blower housing and the fl ue gas passages leading to and from
the combustion blower. Clean the inner surface of the Proof of
Fire Switch located on the Blower housing. When reinstalling
the motor, check the gasket between the motor and the fan
housing, a new gasket may need to be installed if damaged.
Place the motor back on the fan housing (motor down) and rotate
clockwise to lock the fl ange, hand tighten the six screws.
Fig. #18

Cleaning the Convection Blower:

To clean the convection blower, remove the right cabinet side
(see previous page). Disconnect the stove power cord from the
electrical outlet. Using a 3/8" wrench, remove the two bolts (Fig
#19) securing the blower to the blower duct. Slide the blower
out the side towards you disengaging it from the blower duct.
A vacuum can be used to remove any dust accumulation on
the blower's blades or inside the blower duct. Caution should
be used not to damage the blower's blades during cleaning.
To reinstall the blower, slide the blower back into the retaining
lip and install the screws.
Fig. #19 REMOVE
PELLET STOVES
1/4"hex head screws

Door Removal

CAUTION: Do not open the Firebox door when the stove is
hot or operating.
To remove the door, rotate the door handle clockwise to release,
and swing the door open. Lift the front door up and off the hinges.
To reinstall the door, repeat the steps in reverse order.

Back Grill Removal

To remove the back grill, loosen the three screws securing the
grill to the chassis. The back can now be pulled up and off of
the stove. Installation is the reverse.
17 PS45 CLASSIC 151211-24