Cleaning Glass; Ash Pan Removal And Cleaning; Inspect Gaskets; Cleaning The Heat Exchanger - Warmland PS45 Classic Series A Installation And Operating Instructions Manual

Fig. #11
Lift out the Stainless Steel Liner by pulling the Burn-Pot
Assembly towards you, then lift up. Disengage the Burn-Pot from
the inlet tubes and remove. Empty the ash from the Burn-Pot
and re-install. Scrape the bottom and sides of the pot with a
screwdriver to remove all ash and clinkers from these surfaces
if needed. Make sure all the holes in the pot are open. Place
the Burn-Pot Liner back into the Burn-Pot. Push back until the
ignitor tube aligns and the tabs on the front of the liner engage.
Re-install the Burn-Pot Mixer Bar and Grate.

Cleaning Glass

CAUTION: Do not clean glass when hot. Do not open the front
door when the stove is hot. To open the door, rotate the handle
clockwise until it clears the catch. Clean the glass using a soft
cloth or paper towel and household glass cleaner or wood stove
window cleaner. A damp cloth with a small amount of ash from
the fi rebox can also be used to clean the glass.

Ash Pan Removal and Cleaning

CAUTION: Do not remove the ash pan when the stove is hot.
To remove the Ash Pan, Rotate the latch counter-clockwise
to release the ash pan. Pull the Ash Pan up then out from the
stove. Vacuum out the Ash Pan enclosure before inserting the
Ash Pan.
Fig. #12
To close, push the Ash Pan in until the bottom catches and
drops down. Make sure the Ash Pan is tight to the face of the
Ash Pan enclosure, then tighten the Latch.
Note that if the ash pan does not seal tightly to the stove, the
auger may not turn and the stove will shut down.
PELLET STOVES
CAUTION:
Disposal of Ashes - Ashes should be placed in
a metal container with a tight fi tting lid. The closed container
should be placed on a non-combustible fl oor or the ground – well
away from all combustible materials, pending fi nal disposal. If
the ashes are disposed of by burial in soil or otherwise locally
dispersed, they should be retained in the closed container until
all cinders have been thoroughly cooled.

Inspect Gaskets

Inspect the condition of the rope gasket around the door,
window and ash pan, periodically, and replace if necessary.
Inspect the die-cut gaskets on the blowers when cleaning and
replace if necessary.

Cleaning the Heat Exchanger

Do not operate the heat exchange scraper
CAUTION:
when the stove is ho
t.
Located at the center of the grill on the top front of the stove
is a 5/16" Stainless Steel rod that is attached to the scraper
surrounding the heat exchange tubes. To remove ash build-up
and maintain heat efficiency from the stove, pull this rod in and
out at least once a week when the stove is cold.
Fig. #13
15 PS45 CLASSIC 151211-24