Handset Section - Sanyo CLT-186X Service Manual

TEST MODE
HANDSET SECTION
1. Start-Up
(1) Startup of the Test mode by the microcomputer parts
Before power ON, select the microcomputer ports, 2pin (Hight or Low), 4pin-8pin (shorl or open), 5pin-8pin (short or open), 4pin-l 1pin
(short or open).
NOTE: The all keys input are ignored at the state which the pins of microcomputer are shorted.
36 pin
I
short pin
I
mode
I
Channel
I
HIGH none Usual mode
——
LOW none Test Mode (Remote Unit Call)
10CH
4pin-8pin (Flash key) Test Mode (Remote Unit Call) RX MUTE ON
7 CH
5pin-8pin (# key) Test Mode (Remote Unit Call)
6 CH
I 4pin-ll pin (R/P key) I Test Mode (Remote Unit Call)
I
1 CH
I
(2) Start up of the Test mode by operation of Power ON
The Test Mode is started up by pressing"1" and"9 keys simultaneously at power on.
When the Test Mode begins, a beep is heard.
Test mode will be Remote Unit Call Status. (channel+ 10ch)
In case of Test mode in this way, to change the usual mode, press "lNT/PAGE key.
When the Usual Mode begins, a beep (0.5sec) is heard.
2. The states of
test mode
state name
mode specified key
TX POWER
TX MUTE
RX MUTE
TX DATA channel
NORMALTALK MODE
Press "*" key.
ON
OFF
OFF
OFF
01-10
Hands-Free talk
Press "SPEAKER" key.
ON
OFF
OFF
OFF
01-10
TX DATA SEND MODE
Press "TALK key.
ON
ON
ON
ON
01-10
STANDBY MODE
Press "END" key.
OFF
--
ON
-. 01-10
Directly Specify CH.
Press W' key.
ON
OFF
OFF
OFF 06
Directly Specify CH.
Press "REDIAIJP" key.
ON
OFF
OFF
OFF 1
Directly Specify CH.
Press "FLASH" key.
ON
OFF
ON
OFF 7
-15-