Sanyo CLT-186X Service Manual page 17

TEST MODE
3. Setting of PLL channel.
1 Press two numeric keys (01-10: channel No.)
2 Press "*" or "SPEAKER" or "TALK" or "END" key.
For example: TALK MODE 8 channel
~ "8+ "*.
4. Others
(1) "DIAL LED":
Press "END" key. +
lights
Press the other key. +
turns off
(2) Volume Control
Volume Control Normal/Loud switch over each time the "MEMORV key is pressed.
Initial Volume is Loud.
(3) RX MUTE ON/OFF
RX MUTE ON/OFF switch over each time the CHANNEL key is pressed.
(4) Key Monitor detection
Each time a key is pressed, the TALK LED lights and the key monitor sounds.
Key monitor inspection mode
Keys are pressed disorderly, and if after all keys (without "lNT/PAGE or "VOICE MAIL" key) have been pressed, the TALK LED lights
for approximately 0.5 sec. and a beep is heard.
-16-