Oki OKIPAGE 12i Service Handbook page 161

(5) Operator Panel Menu Disable
• This function is for enabling and disabling the operation panel menu functions (Menu 1,
Menu 2, Tray Select, Copies and Paper Size).
LCD display USER MNT
Press the
MENU key.
MENU
RESET
Press the
MENU key.
HEX DUMP
Press the
MENU key.
DRUM CNT
RESET
Press the
MENU key.
RSRC SAV
REC BUF
Press the
MENU key.
OP MENU
ENABLE *
Press the
MENU key.
X ADJUST
0mm *
Press the
MENU key.
Y ADJUST
0mm *
2ND TRAY
5 *
PLACE PG
CENTER *
Press the
MENU key.
SETTING
Press the
0 *
(Note1)
MENU key.
INITIAL-
IZING
ON LINE
XXX
After the completion
Press the
of processing
ENTER key.
MENU
RESET'NG
Press the
ENTER key.
ON-LINE
HEX DUMP
After the completion
Press the
of processing
ENTER key.
DRUM CNT
RESET'NG
AUTO
Press the
Sets the size of area where, at switching either of PCL
OFF
or key.
and POSTSCRIPT to the counterpart, environment such
200KB
as permanent DLL and MACRO can be saved for the
400KB
switched part, and when it is returned, the saved envi-
800KB
ronment can be recalled.
1.2MB
Enable only when PS option + additional memory is con-
1.8MB
nected and cable of obtaining 10% assignment to the
2.4MB
size of additional memory which is installed when this
setting is selected.
8.4MB
9.8MB
11.2MB
AUTO
Press the
Setting of receiving buffer.
8KB
or key.
If you select a large value, the data transmitting time from
20KB
PC will be shortened, but Memory Overflow become easy
50KB
to happen.
100KB
1MB
Press the
Writing into the EEPROM is performed after pressing the
or key.
OP MENU
ENTER key. Press the ON LINE key if you wish
DISABLE
to get out of this mode.
Press the
Writing into the EEPROM is performed after pressing the
or key.
ENTER key. Press the ON LINE key if you wish to get out of
X ADJUST
this mode.
+0.25mm
(Range of Adjustment: +2.00mm to -2.00mm; 0.25mm steps)
Press the
Writing into the EEPROM is performed after pressing the
or key.
X ADJUST
ENTER key. Press the ON LINE key if you wish to get out of
+0.25mm
this mode.
(Range of Adjustment: +2.00mm to -2.00mm; 0.25mm steps)
Press the
In the feeding destination selecting command (ESC&I#H) for
2ND TRAY
or key.
PCL5 Emulation, # designated for 2nd Tray is set.
1
As compared with mechanical setting position of paper being a
Press the
PLACE PG
ENTER key. center alignment, a printing image is moved in accordance with
LEFT
the left alignment which is the same as HP (canon).
Enable only for PCL.
Press the
0 *
or key.
Note1) For Ver.1.18 F/W, "SETTING" menu item
+ 1
+ 2
- 1
- 2
D - 2
ON-LINE
XXX
ON-LINE
XXX
is in the Engine Maitenance mode.