Start Installation - HP WL110 Quick Install Manual

2. Enable PCMCIA Services (page D-4)
3. Enable Network Support (page D-5) for the workstation.

Start Installation

To install the hp wireless PC card WL110 on a computer
running Windows NT 4.0, proceed as follows:
1. Insert the hp wireless PC card WL110 into your
computer.
2. Power up your computer.
3. Continue with Enabling PCMCIA Services.
Note: To be able to perform the steps as described on the
following pages, you will need:
To verify these settings:
— During start-up, check the blue start-up screen to
Windows NT Service Pack v4.0 or higher
The privileges of the Windows NT station
administrator.
verify which NT Service Pack is installed on the
computer.
Installation for Windows NT D-3