Monogramming; Embroidery - Kenmore 385.101118 Owner's Manual

+ Monogramming
Set the Machine
Stitch selector
Stitch ength
0 to 24
Top thread tens_en
control 1 to 4
Satin stitch foot
!.
28
k,
Here's How
1. Set the same as satin stitch.
2. Back the fabric with paper or
interfacing.
3. Draw the design on to the fabric
with tailor's chalk.
4. Satin stitch, adjusting the stitch
width as necessary to form each
pattern.
5. If using paper, carefully remove it
when you have finished sewing.
• Embroidery
f
Set the Machine
Stitch selector
Top thread tension Stitch length
6ontrol 1 to 4 Any number
_. (not necessary
tO adjust)
No presser O) foot
- Darning plate
Here's How
1. Put the darning plate on the needle
plate (see p. 2__33).
2. Remove presser foot.
3. Adjust the stitch width as desired
(see p. 1__8).
4. Draw the design on to the fabric with
tailor's chalk.
5. Stretch the fabric between
embroidery hoops and place under
the needle.
6. Lower the presser foot lever to
engage the top thread tension.
7. Holding the top thread in your left
hand, rotate the hand wheel toward
you one comp[ete turn.
Pull the top thread to draw the
bobbin thread through to the
surface of the fabric.
8. Using a medium speed, stitch along
the marked outline, guiding the
fabric carefu Ily by hand.