Left-Side Steering Wheel Lever - Volvo XC90 Owner's Manual

Lever positions
Turn signals, lane change position
Turn signals, position for normal turns
High beam flash
Toggle between high and low beams,
Home Safe lighting
Factory setting
1
Turn signals
When turning
Move the lever as far up or down as possible
(to position 2) to start the turn signals. The
turn signals will be cancelled automatically by
the movement of the steering wheel, or the
lever can be returned to its initial position by
hand.
When changing lanes
The driver can automatically flash the turn
signals 3 times by:
•
Moving the turn signal lever up or down
to position (1) and releasing it.
•
Moving the lever up or down to position
(2) and immediately back to its original
position.
NOTE
•
This automatic flashing sequence can
be interrupted by immediately moving
the lever in the opposite direction.
•
If the turn signal indicator flashes
faster than normal, check for a
burned-out turn signal bulb.
02 Instruments and controls

Left-side steering wheel lever

High/low beam headlights
Continuous high beams
1. Turn the ignition key to position II.
2. With the light switch in position
(see page 67) pull the turn signal lever
toward the steering wheel to toggle
between high and low beams.
High beam flash
1. Turn the ignition key to position II.
2. Pull the turn signal lever to position (3).
The high beams will remain on until the
lever is released.
Home safe lighting
When leaving your vehicle at night, home safe
lighting can illuminate the area in front of the
vehicle.
1. Remove the key from the ignition switch.
2. Pull the turn signal lever as far as possible
toward the steering wheel and release it.
3. Exit the vehicle and lock the doors.
The headlights and parking lights will illumi-
nate and remain on for 30
The time interval can be changed by a trained
and qualified Volvo service technician.
02
,
1
, 60 or 90 seconds.
71