Turning A Square Corner - Kenmore 1357 Instructions Manual

Be sure both threads are drawn back
under the presser foo/t. Lower needle
into fabric about 1/2 inch from
beginning of seam. Turn the reverse
stitch ,control clockwise and stitch in
reverse until needle reaches beginning
of seam. Release control and complete
seam. When you reach the end, turn the
control clockwise and sew back over
1/2 inch of completed seam;
TURNING A SQUARE CORNER
To turn a square corner 5/8" from the
fabric edge, stop stitching with the
needle tip piercing the fabric, when
reaching the cornering guide as shown.
Raise the presser foot, turn fabric. New
stitching line will align with 5/8" seam
guide on side of needle plate. Lower the
presser foot and begin stitching in new
direction.
24