Delete All Fingerprints; User Code Set Up; Unlock Using A User Code - Scyan X7 User Manual

rejections, the system will shut off. You need to lift your finger at least 2 inches away
from the sensor, then place finger back on sensor to re-active the sensor
3. Delete a single fingerprint:
3.1. Login using Programming code or an administrator fingerprint. Press * then
enter Programming code, followed by pressing #, or Press * followed by placing an
administrator fingerprint on the sensor. If login is successful, you will hear one long
beep and the keypad will show blue light. Otherwise, you will hear two short beeps and
the keypad will show red light. Repeat if login fails.
3.2. Press 2 and then *.
3.3. Enter the user ID, then press #.
If the deletion is successful, you will hear one long beep and the keypad will show
blue light. Otherwise, you will hear two short beeps and the keypad will show red light.
3.4. Repeat step 3.3 within 5 seconds if you want to delete more fingerprint users.
The system will log out after 5 seconds if you don't press any button.

4. Delete all fingerprints:

Follow 3.1 to login the system, press 3 *, then press 3 * again, and then press #. If
the deletion is successful, you will hear one long beep and the keypad will show blue
light. Otherwise, you will hear two short beeps and the keypad will show red light.
Repeat as necessary.
Code User
The lock is capable of storing up to100 code users. Each code user is assigned a code
user ID. A code user ID can be any number ranging from 0 to 99.

5. User code set up:

5.1. Login using Programming code or an administrator fingerprint. Press * then
enter Programming code, followed by pressing #, or Press * followed by placing an
administrator fingerprint on the sensor. If login is successful, you will hear one long
beep and the keypad will show blue light. Otherwise, you will hear two short beeps and
the keypad will show red light. Repeat if login fails.
5.2. Press 4 *.
5.3. Enter a user ID, press #, enter a user code, press *, and enter the user code
again, press #. The user ID can be any number ranging from 0 to 99. The user code can
be any combination of 4-12 digits. If the setup is successful, you will hear one long beep
and the keypad will show blue light. Otherwise, you will hear two short beeps and the
keypad will show red light.
5.4. Repeat step 5.3 within 5 second if you want to set up more user codes. The
system will log out after 5 second if you don't press any button.

6. Unlock using a user code:

- 6 -