Programming Code; Specifications - Scyan X7 User Manual

Fingerprint keypad lock
Hide thumbs


 Key override feature could be disabled.
 9V battery may be attached as an additional power source.
 Double-shell heavy duty construction design.
 Low power alert.


 Optical sensor.
 Standard 12-key keypad.
 Tubular latch.
 Adjustable backset 2 ⅜" or 2 ¾".
 Fit door thickness between 1 ¼" and 2 ¼" (Order screws for door thickness
between 2 ¼" and 2 ½").
 Operation temperature from -4° F to 150° F (-20° C to 65° C).
 Powered by 4 AA Alkaline batteries (NOT included).
 Lock designed for INTERIOR door ONLY.
 One year limited manufacturer's warranty.
Important Note:
1. For valid key entry, press and hold a key until you hear a beep and see blue light, then
release the key.
2. During programming, system will log out if a user doesn't press any keys for 5
seconds. The keypad will flash red twice to indicate system log out. If you make a
mistake during programming, please wait for the system to log out and then login again.
3. Try to use finger to unlock for 5 or more times after you enroll your fingerprint in
system. Let system catch more fingerprint templates.
4. Fingerprint sensor should activate automatically when a user place finger on the
sensor, otherwise press # to active fingerprint sensor. To solve the problem, take one
battery out, press any key for 2 seconds, and then place the battery back.
5. Improper operation may cause system crash; the system doesn't accept any command.
To solve the problem, take one battery out, press any key for 2 seconds, and then place
the battery back. Try again if system doesn't recover. Reset system if problem is still
I. Programming Code
The lock has one Programming Code. Programming Code allows a lock owner to login
the lock system and register a user password or a user fingerprint. The factory-set default
Programming Code is 123456. It is recommended that a lock owner should change the
default Programming Code to a customized Programming Code. A customized Program
Code can be any combination of 4-12 digits.
To change Programming Code, please follow the following steps:
 press 0 and then *
- 4 -

Hide quick links: