Troubleshooting Guide - Bosch UML-172-90 User Manual

24 en | TroubleShooting Guide
9

TroubleShooting Guide

Problem
No image is displayed on
screen
"Going to Sleep"
message is displayed
Display image is not
centered, is too small, or
too large in the PC mode
Vertical or horizontal
noise is present in the
picture
Incorrect colors
The error message "Out
of Range" is displayed
F.01U.075.713 | 1.0 | 2008.03
Solution
– Check that the power cord of the monitor is securely
connected into the wall outlet or grounded extension cable or
strip.
– Power switch should be in the ON position and the LED lit.
– Check that the Brightness and/or Contrast adjustments of the
display have not been turned down to minimum levels.
– The signal cable should be completely connected to the video
card/computer.
– The video card should be completely seated in its slot and the
computer switched ON.
Push the down key to activate the Autoset function.
-or-
Adjust the Clock and Phase in the PC OSD submenu.
Push the down key to activate the Autoset function (for VGA inputs
only).
-or-
Adjust the Clock and Phase in the PC OSD submenu.
– Press the Menu button on the front panel of the monitor, then
press the down arrow to select the Color Tone menu. Press
the down arrow on the front panel and select Cool, Warm, or
Normal.
- or -
– Press the Menu button on the front panel of the monitor, then
press the right arrow to select the Setup menu. Press the
down arrow on the front panel and select Recall to reset to
the default settings.
PC is operating with either a resolution or timing mode that is not
supported by the monitor. Change the PC timing mode to one of
the valid combinations below:
640 x 480; 60/72/75 Hz
800 x 600; 60/72/75 Hz
1024 x 768; 60/70/75 Hz
1280 x 1024; 60 Hz
1600 x 1200; 60 Hz
User's Manual
High Performance LCD Monitors
Bosch Security Systems, Inc.