4.5.1 Connecting PC Audio Connecting the PC Signal to the Monitor 4.6.1 HDMI 4.6.2 4.6.3 Connecting an Alarm Trigger Single / Multiple Monitor Configuration Bosch Security Systems, Inc. Table of Contents | en Installation Manual F.01U.076.723 | 2.0 | 2009.03...
Page 4
Picture / Sound Menu PIP Menu Setup Menu 5.7.1 Configuring Alarm Relay Inputs 5.7.2 Configuring Auto Switching Power Management Power Consumption LED Indicator Maintenance TroubleShooting Guide F.01U.076.723 | 2.0 | 2009.03 High Performance LCD Monitors Installation Manual Bosch Security Systems, Inc.
Lightning - For added protection during a lightning storm, or when leaving this unit unattended and unused for long periods, unplug the unit from the wall outlet and Bosch Security Systems, Inc. Installation Manual Safety | en F.01U.076.723 | 3.0 | 2009.03...
Page 6
For 24 VAC units, voltage applied to the unit's power input should not exceed ±10%, or 28 VAC. User- supplied wiring must comply with local electrical F.01U.076.723 | 3.0 | 2009.03 High Performance LCD Monitors Installation Manual Bosch Security Systems, Inc.
Page 7
17. Attachments, changes or modifications - Only use attachments/accessories specified by the manufacturer. Any change or modification of the equipment, not expressly approved by Bosch, could void the warranty or, Bosch Security Systems, Inc. Installation Manual Safety | en...
When a cart is used, use caution and care when moving the cart/apparatus combination to avoid injury from tip-over. Quick F.01U.076.723 | 3.0 | 2009.03 High Performance LCD Monitors Installation Manual Bosch Security Systems, Inc.
Page 9
This device is intended for use in public areas only. U.S. federal law strictly prohibits surreptitious recording of oral communications. Your Bosch product was developed and manufactured with high-quality material and components that can be recycled and reused. This symbol means that electronic and electrical...
Page 10
Please dispose of these units at an environmentally compatible recycling facility, per European Directive 2002/96/EC. Environmental statement - Bosch has a strong commitment towards the environment. This unit has been designed to respect the environment as much as possible.
Page 11
Network Voltage (TNV) circuits. Video loss - Video loss is inherent to digital video recording; therefore, Bosch Security Systems cannot be held liable for any damage that results from missing video information. To minimize the risk of lost digital information, Bosch Security Systems recommends multiple, redundant recording systems, and a procedure to back up all analog and digital information.
Page 12
AVERTISSEMENT: Suite à différents tests, cet appareil s’est révélé conforme aux exigences imposées aux appareils numériques de Classe A en vertu de la section 15 du règlement F.01U.076.723 | 3.0 | 2009.03 High Performance LCD Monitors Installation Manual Bosch Security Systems, Inc.
Page 13
Circuit Television Equipment, UL 2044. UL Certification does not cover the performance or reliability of the security or signaling aspects of this product. UL MAKES NO REPRESENTATIONS, WARRANTIES, OR CERTIFICATIONS WHATSOEVER REGARDING THE Bosch Security Systems, Inc. Installation Manual Safety | en F.01U.076.723 | 3.0 | 2009.03...
Page 14
CERTIFICATIONS WHATSOEVER REGARDING THE PERFORMANCE OR RELIABILITY OF ANY SECURITY OR SIGNALING-RELATED FUNCTIONS OF THIS PRODUCT. Copyright This user guide is the intellectual property of Bosch Security Systems, Inc. and is protected by copyright. All rights reserved. Trademarks All hardware and software product names used in this document are likely to be registered trademarks and must be treated accordingly.
High Performance LCD Monitors Customer Support and Service If this unit needs service, contact the nearest Bosch Security Systems Service Center for authorization to return and shipping instructions. Service Centers Repair Center Telephone: 800-566-2283 Fax: 800-366-1329 E-mail: repair@us.bosch.com Customer Service...
Page 16
| Safety Warranty and more information For additional information and warranty queries, please contact your Bosch Security Systems representative or visit our website at www.boschsecurity.com. F.01U.076.723 | 3.0 | 2009.03 High Performance LCD Monitors Installation Manual Bosch Security Systems, Inc.
Verify that all the parts listed in the Parts List below are included. If any items are missing, notify your Bosch Security Systems Sales or Customer Service Representative. The original packing carton is the safest container in which to transport the unit and must be used if returning the unit for service.
Remote control sensor LED Indicator Power On (green) Power Off, Standby (red) Power Button Display Power (On/Off) F.01U.076.723 | 3.0 | 2009.03 High Performance LCD Monitors Installation Manual Scrolls up in the OSD Scrolls down in the OSD Bosch Security Systems, Inc.
Page 19
S-Video (Y/C) IN S-Video (Y/C) OUT Audio IN (AV1, S-Video) Audio OUT (AV1, S-Video) Audio IN (AV2) Audio OUT (AV2) 12 V Adaptor Bosch Security Systems, Inc. Bottom Panel Number Connector HDMI IN DVI IN D-SUB IN PC Stereo IN...
| Unpacking Remote Control This section details the functions and the usage of the Bosch remote control. Button Function POWER Turns the power ON and OFF. SOURCE Selects the PC or Video source. Numbers Numerals 0-9. AUTO Auto adjusts to the graphics adaptor.
Figure 2.4 Remote Control Battery Placement Slide the battery cover back into place. Note: Replace batteries when required or at least once a year. Dispose of used batteries properly. Bosch Security Systems, Inc. Installation Manual Unpacking | en F.01U.076.723 | 3.0 | 2009.03...
Page 22
| Unpacking High Performance LCD Monitors F.01U.076.723 | 3.0 | 2009.03 Installation Manual Bosch Security Systems, Inc.
High Performance LCD Monitors Description The Bosch High Performance Family of LCD monitors display PAL or NTSC standard color pictures in CCTV systems. Two (2) looping Composite Video BNC connector inputs, two (2) looping Audio input RCA, and two (2) looping Y/C (S-Video) inputs using a 4-pin mini-DIN are included.
| Description Power Model No. Rated Voltage Voltage Range Power at Rated Voltage Sync Format UML-172-90 120/230 VAC 50/60 Hz UML-192-90 120/230 VAC 50/60 Hz UML-202-90 120/230 VAC 50/60 Hz F.01U.076.723 | 3.0 | 2009.03 High Performance LCD Monitors 100 to 240 V <...
High Performance LCD Monitors Installing the Monitor This chapter outlines the procedures to install the UML-172-90, UML-192-90, or the UML-202-90 Series. A qualified service person should install the monitor and adhere to all local codes. Ventilation To prevent overheating, ensure that the ventilation openings on the rear of the monitor are not covered.
| Installing the Monitor 4.2.2 Wall Mount Installation The square mounting holes (100 mm [3.9 in.] centers) are compatible with the Bosch UMM-LW-20B fixed wall mount or the UMM-LW-30B swivel/tilt mount. Figure 4.1 Mounting the Device Connecting the Composite Video Signal to...
4.5.1 Connecting PC Audio The rear bottom panel has PC stereo audio IN and audio OUT. Connect with 1/8 in. mini phono plug jack to Audio IN. Bosch Security Systems, Inc. Installing the Monitor | en Audio 1 Audio 2 Installation Manual F.01U.076.723 | 3.0 | 2009.03...
Dinion camera and sounds a buzzer. Route the coax cable from the Dinion Video output to the AV1 input of the UML monitor. Bosch Security Systems, Inc. Installing the Monitor | en Installation Manual F.01U.076.723 | 3.0 | 2009.03...
Page 30
Press the Menu button three (3) times to exit the menu and to return to the video display. F.01U.076.723 | 3.0 | 2009.03 Trigger Enable Trigger Type Trigger Input Buzzer Trigger Time Trigger Option Display Type :Move :Input Installation Manual High Performance LCD Monitors External :Menu Bosch Security Systems, Inc.
VIDEO 2 (AV2) IN VIDEO 2 (AV2) OUT Figure 4.8 Multiple Monitor Configuration Number Description Video Camera VIDEO 2 (AV2) IN VIDEO 2 (AV2) OUT Bosch Security Systems, Inc. Installing the Monitor | en Installation Manual F.01U.076.723 | 3.0 | 2009.03...
Page 32
| Installing the Monitor High Performance LCD Monitors F.01U.076.723 | 3.0 | 2009.03 Installation Manual Bosch Security Systems, Inc.
Navigating the Monitor Navigating the Front Panel Use the front panel to make any necessary OSD adjustments to the UML-172-90, UML-192-90, or to the UML-202-90. See the figure below for an explanation of the front panel. Figure 5.1 Front Panel Buttons...
Page 34
10. Press the Menu button again to exit the OSD menu bar. F.01U.076.723 | 3.0 | 2009.03 High Performance LCD Monitors buttons to select a menu. buttons to select a sub-menu item. buttons to toggle the OSD values. Installation Manual Bosch Security Systems, Inc.
Menu button again to exit the OSD. Custom :Move Table 5.1 Custom Menu (Video Mode) Bosch Security Systems, Inc. Function Adjusts the Brightness, Contrast, Color, Tint, and the Sharpness level for video performance of the OSD. (The menu options differ between the Video and PC modes.)
Page 36
Adjusts the tint of the picture (range 0-100). NTSC only. Sharpness Adjusts the sharpness level for video performance (range 0- 100). Phase (Component only) F.01U.076.723 | 3.0 | 2009.03 High Performance LCD Monitors Brightness Contrast :Input :Menu Installation Manual Bosch Security Systems, Inc.
Alternates between the main and sub picture for the PIP mode. Continuously press to change selection. Sound Select Select the sound source from either the Main or the PIP input source (only available when PIP is enabled) Bosch Security Systems, Inc. Navigating the Monitor | en Input Source Size...
Firmware Version Displays the release level of the monitor firmware. F.01U.076.723 | 3.0 | 2009.03 High Performance LCD Monitors Reset Language English OSD Tone Blue Blue Screen Key Lock Trigger Auto Switching Firmware Version X.XX :Input Installation Manual :Menu Bosch Security Systems, Inc.
Option Definition Trigger Enable Activates the trigger feature. Trigger Type Specifies the source of the alarm. This option is always set to External. Bosch Security Systems, Inc. Navigating the Monitor | en Trigger Enable Trigger Type External Trigger Input Buzzer...
Page 42
(FULL). F.01U.076.723 | 3.0 | 2009.03 High Performance LCD Monitors Installation Manual Selections S-Video Component HDMI ON or OFF 0–100 seconds (normally closed) (normally open) High (2–5 V) Low (< .6 V) PIP & FULL FULL Bosch Security Systems, Inc.
Opens another menu in which you select the input sources to include in the Auto Switching cycle. Time Select the amount of time, in seconds, that the monitor displays each selected input source. Bosch Security Systems, Inc. Navigating the Monitor | en Auto Switching Input Time...
Page 44
Select On to include the input source in the cycle. – Select OFF to remove the input source from the cycle. F.01U.076.723 | 3.0 | 2009.03 High Performance LCD Monitors S-Video Component HDMI :Input Installation Manual :Menu Bosch Security Systems, Inc.
Green STANDBY Flashes SUSPEND ACTIVE OFF UNSUPPORTED Green MODE POWER OFF Bosch Security Systems, Inc. Power Consumption 70 W 10 W 10 W 10 W Monitor Operation Normal operation Screen blanks after idle time and some electronic circuits or all circuitry in the monitor shuts down.
Page 46
| Power Management High Performance LCD Monitors F.01U.076.723 | 3.0 | 2009.03 Installation Manual Bosch Security Systems, Inc.
Ethyl alcohol – Ethyl acid – Toluene – Methyl chloride – Ammonia Use of these materials may permanently damage the polarizer due to a chemical reaction. Bosch Security Systems, Inc. Installation Manual Maintenance | en F.01U.076.723 | 3.0 | 2009.03...
Page 48
| Maintenance High Performance LCD Monitors F.01U.076.723 | 3.0 | 2009.03 Installation Manual Bosch Security Systems, Inc.
Picture/ Sound menu: – Ensure that the Mute option is set to OFF. – Ensure that the Volume is set to an audible level. Bosch Security Systems, Inc. TroubleShooting Guide | en Installation Manual F.01U.076.723 | 3.0 | 2009.03...
Page 50
640 x 480; 60/72/75 Hz 800 x 600; 60/72/75 Hz 1024 x 768; 60/70/75 Hz 1280 x 1024; 60 Hz 1600 x 1200; 60 Hz F.01U.076.723 | 3.0 | 2009.03 High Performance LCD Monitors Installation Manual Bosch Security Systems, Inc.