Wall Mount Installation; Connecting The Composite Video Signal To The Monitor; Connecting The Y/C (S-Video) Signal To The Monitor - Bosch UML-172-90 User Manual

High Performance LCD Monitors
6.2.2

Wall Mount Installation

The square mounting holes (100 mm [3.9 in.] centers) are compatible with the Bosch UMM-
LW-20B fixed wall mount or the UMM-LW-30B swivel/tilt mount.
Figure 6.1 Mounting the Device
6.3

Connecting the Composite Video Signal to the Monitor

There are two (2) BNC connectors located on the rear side panel of the monitor for composite
video input and two (2) BNC connectors for composite video outputs (see Figure 3.3).
Note: All video inputs are passive loop-through. The impedance is automatically set to 75 ohm
by the input of the signal on the input connector, while operating in a single connection mode
(see Figure 6.6). If a cable is also connected to the output connector, the video signal can be
passed on to another monitor connected to it via the passive loop-through function. Up to
three (3) monitors may be connected in this manner (see Figure 6.7).
Note: To select between AV1 and AV2, press Input (see Figure 3.1, Item 1 or Figure 3.2, Item
1) located on the front of the monitor.
6.4

Connecting the Y/C (S-Video) Signal to the Monitor

There is one (1) mini-DIN type connector for the S-Video (Y/C) input (see Figure 6.2) on the
rear side panel.
Note: Both Y and C inputs are terminated with 75 ohm.
Figure 6.2 Y/C Connection Pinout
Number Input
1
2
3
4
Bosch Security Systems, Inc.
GND
GND
Y-signal IN or OUT
C-signal IN or OUT
User's Manual
Installing the Monitor | en 15
F.01U.075.713 | 1.0 | 2008.03