Installation Location - Panasonic CX-DP880U User Manual

Installation
(continued)
E
N
G
L

Installation Location

I
S
Avoid installing the unit in the following locations.
H
¡In areas hit by direct sunlight, hot air from the heater, or any other high-temperature location.
9
¡In an area where you cannot firmly secure the unit, or in high-vibration areas.
¡In areas with high humidity or high dirt and dust levels.
Select the mounting angle
Default: H
Use a screwdriver to set the angle-adjusting screw to the position "V" or "H",
depending on the mounting angle selected.
This unit can be set in the five directions: horizontal, vertical, and the positions A
(22.5°), B (45°), and C (67.5°). Mount the unit by referring to the figures below.
Cautions:
¡Set the angle-adjusting screw to the same angle as the unit is installed.
¡Set the holes to the same positions for both left and right.
H (0°) A (22.5°) A (22.5°)
H H H H
V V V V
(L) (R) (L) (R)
Installation
Typical horizontal installation
(Normal) (Up-side down)
Typical vertical installation
(Normal) (Up-side down)
14
CX-DP880U
Adjust the angle with a screw driver
B (45°) B (45°) C (67.5°)
H H H H
V V V V
(L) (R) (L) (R)
Angle Selecting a mounting angle
Limit to less than 10 degrees.
Set the screw to the same
Limit to less than 10 degrees.
positions for both left and right.
Do not tilt in this Limit to
direction. less than
Limit to less than 10 degrees.
10 degrees.
Set the screw to the same
positions for both left and right.
Typical horizontal installation
1
Mount a mounting bracket (L) or (R) on either side
of the control unit with a hex. bolt together with
double washers (M4 x 8 mm).
H
V
H
r Mounting bracket (L)
V
3
Use a cutter to cut a small cross in the carpet in
accordance with the locations of the M5 bolts of the
base brackets.
V (90°)
H H
V V
w Base bracket x 2
(L) (R)
Fix both the base brackets and the double-faced adhesive
tape to a mounting surface below the carpet.
H
Typical vertical installation
V
Mount the unit with the mounting bracket on either side
with a hex. bolt with double washers (M4 x 8 mm).
r Mounting bracket (L)
H
V
q Hex. bolt with double washers
(M4 x 8 mm) x 4
2
Select a location where the unit should be mounted.
Fix the base brackets with a double-faced adhesive
tape.
t Mounting bracket (R)
q Hex. bolt with double
y Double-faced adhesive tape x 2
washers (M4 x 8 mm) x 4
4 Mount the unit on the carpet with four hex. nuts
(M5).
Carpet
Relationship between mounting
holes and angles
H B
L
V
t Mounting
A
bracket (R)
Mounting bracket (L)
The relationship between mounting holes and angles of
the mounting brackets (L and R) is illustrated above.
Symbols corresponding to the mounting angles are
marked near the respective holes. Select the correct holes
in accordance with the mounting angles to be used.
E
N
G
L
I
S
H
10
w Base bracket x 2
e Hex. nut (M5) x 4
Carpet
H
B
V
V
C C
B
B
A C C A
R
V
A
H
H
Mounting bracket (R)
15
CX-DP880U