Table of Contents
Advertisement
Device
Signal
No.
RX10
RX11
RX12
RX13
RX14
Reserved
RX15
RX16
RX17
RX18
RX19
RX1A
Error status flag
RX1B
Remote station ready
Note: With Pr. 190 to Pr. 192 (output terminal function selection), you can set the output signals of device No.s RX2,
RX6, RX7. For full information, refer to the inverter manual.
Reserved for the system.
Switched on when an inverter error occurs (protective function is activated).
Switched on when the inverter goes into the ready status on completion of initial setting
after power-on or hardware reset.
(Used as an interlock for read/write from/to the master station.)
Switched off when an inverter error occurs (protective function is activated).
27
COMMUNICATION SPECIFICATIONS
Description
Advertisement
Table of Contents
