DRYER EXHAUST CHANGE
DUCT
TAPE
DUCT
TAPE
DUCT
TAPE
43
WARNING!
BEFORE PERFORMING THIS EXHAUST INSTALLATION,
BE SURE TO DISCONNECT THE DRYER FROM ITS
ELECTRICAL SUPPLY.
TO REDUCE THE RISK OF PERSONAL INJURY, ADHERE
TO ALL INDUSTRY RECOMMENDED SAFETY
PROCEDURES INCLUDING THE USE OF LONG SLEEVED
GLOVES AND SAFETY GLASSES. FAILURE TO FOLLOW
ALL OF THE SAFETY WARNING IN THE MANUAL COULD
RESULT IN PROPERTY DAMAGE, PERSONAL INJURY OR
DEATH.
emove a screw and the exhaust duct.
1.
Detach and remove a knockout at the botton,
2-1.
left or right side as desired. ( ight side vent not
available on gas dryer)
, ,
the order of work.
econnect the another duct [11 in (28cm)] to
2-2.
the blower housing, and attach the duct to the
base. (Duct is a service part)
Pre-assemble 4" elbow with 4" duct.
3-1.
Wrap duct tape around joint.
Insert the elbow duct assembly through the side
3-2.
opening and connect the elbow to the internal
duct.