Light Bulb Replacement; Fuse Replacement - Cushman Shuttle 2 Owner's Manual

MAINTENANCE
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.

LIGHT BULB REPLACEMENT

To reduce the possibility of premature bulb failure, do not touch new bulbs with bare fingers. Use clean, dry tissue or
paper towel to handle the glass portion of the bulb.
For vehicles equipped with lights mounted below cowl, locate bulb socket on backside of light bar and turn bulb socket
a quarter turn counterclockwise to unlock and pull out bulb. Insert new bulb and rotate socket a quarter turn clockwise
to secure.
Similarly replace the turn signal light bulb, locate bulb socket on backside of light
bar and turn bulb socket a quarter turn counterclockwise to unlock and pull out
bulb. Insert new bulb and rotate socket a quarter turn clockwise to secure.
5
To replace the tail and brake light bulb, roll the rubber bezel from around the
edge of the taillight and remove lens. Install replacement bulb and replace lens.
To replace the tail and brake light bulb, remove hardware securing lens and
remove lens. Install replacement bulb.

FUSE REPLACEMENT

To replace fuses, locate the fuse block under the driver side seat. Pull out old
fuse and replace with a new automotive type fuse. Headlight and taillight bulbs
and fuses are available from a local Distributor, an authorized Branch or the Ser-
vice Parts Department.
5 - 8
Inside
of Cowl
Headlight
Casing
Screw
Headlight
Bulb
Roll Rubber
Bezel Away
From Body
Tail/Brake
Light
Rear
Fender
Rear
Fender
Tail Light
Lens
Tail Light
Bulb