System Edit Mode; Powering Up - Ada MP-2 Owner's Manual

System Edit Mode

The System Edit mode display is essentially the same as the Program Edit mode display, but
in many cases the parameters take the form of a question, asking if you wish to execute the
named System function. These questions are answered by pressing the "
("No") button, indicated by an arrow pointing up.These up-facing arrows also sometimes
indicate submenus or steps in a procedure.

Powering Up

• After connecting the MP-2 as described in the Getting Started chapter, turn on
the power switch on the rear panel. Be sure the Output Level control is turned
all the way down and the Room EQ control is set to Normal.
When switched on, the MP-2 will first display a screen with ADA's name, then a screen
identifying the unit as an MP-2 and showing the software version installed:
The MP-2 is a tube preamp, and tubes take a few moments to warm up when they are first
switched on. During this period, the MP-2's display will show this message:
• Slowly raise the Output Level control until the volume is comfortable. Be careful
not to overload the input of the amplifier or mixer into which the MP-2 is
plugged.
Page: 18
" ("Yes") or "v"
A