Table of Contents
Advertisement
Care & Cleaning
Oven
Light
Wire
Holder
Changing
the Oven
Light
On some models, the oven light automatically turns on when the door is opened.
Some models have a switch located on the control panel to turn on the light. The
oven light is located at the rear of the oven and is covered with a glass shield held
by a wire holder. The glass shield must be in place whenever the oven is in use.
To replace the oven light:
1.
Turn electrical power off at the main source or unplug the range.
2.
Press wire holder to one side to release the glass shield.
3.
Replace bulb with a new 40 watt appliance bulb.
4.
Replace glass shield over bulb and snap wire holder into place.
5.
Turn power back on again at the main source (or plug the range back in).
6.
The clock will then need to be reset. To reset, see Setting the Clock and
Minute Timer in this Use & Care Guide.
_r _
Be sure the range is unplugged and all parts are COOL before
replacing oven light. Wear a leather-faced glove for protection against possible
broken glass.
Care and Cleaning
of Stainless
Steel
(some models)
b"
Some models are equipped with stainless steel exterior parts. Special care and cleaning are required for maintaining the
G©
appearance of stainless parts. Refer to the Care & Cleaning table for detailed cleaning instructions.
Adjusting Your Oven Temperature
Your oven control has been precisely set at the factory. This setting may differ from you r previous oven however, so your recipe
times may not give you the results you expect. If you think that the oven is cooking too hot or too cool for your recipe times,
you can adjust the control so that the oven cooks hotter or cooler than the temperature displayed.
To Adjust Oven Temperature:
1.
Press
2.
Set the temperature to 550°F (287°C) by pressing and holding the
A
.
3.
Within 2 seconds, press and hold _
until the 2 digit display appears. Release _.
The display now indicates the
amount of degrees offset between the original factory temperature setting and the current temperature setting. If the oven
control has the original factory calibration, the display will read "0."
4.
The temperature
can now be adjusted up or down 35°F (17°C), in 5°F steps by pressing and holding the
A
or
v
.
Adjust until the desired amount of offset appears in the display. When lowering the oven temperature, a minus sign (-) will
appear before the number to indicate that the oven will be cooler by the displayed amount of degrees.
5.
When you have made the desired adjustment, press _
to go back to the time of day display.
Note: The adjustments made will not change the self-cleaning temperature.
21
Hide quick links:
Advertisement
Table of Contents
