Answering System Settings - Panasonic KX-TG7851FX Operating Instructions Manual

Answering System
parties from listening to your messages
remotely.
Important:
R In order to operate the answering system
remotely, you must first set a remote
access code.
1
M N (right soft key) #306
2
To turn on remote operation, enter the
desired 3-digit remote access code.
3
MOKN a MeN
Deactivating remote operation
Press * in step 2 on "Remote access code"
page 41.
R The entered remote access code is deleted.
Using the answering system
remotely
1
Dial your phone number from a
touch-tone phone.
2
After the greeting message starts, enter
your remote access code.
3
Enter remote commands.
4
When finished, hang up.
Remote commands
Key Operation
1 Repeat message
(during playback)
2 Skip message
(during playback)
4 Play new messages
5 Play all messages
6 Play greeting message
7 Record greeting message
9 Stop recording
Stop playback
0 Turn answering system off
*4 Erase currently playing
message
42
TG7851_61FX(en)_0215_ver011.pdf
Key
*5
*6
*#
*1 If pressed within the first 5 seconds of a
message, the previous message is
played.
Turning on the answering system
remotely
If the answering system is off, you can turn it
on remotely.
1
Dial your phone number from a
touch-tone phone.
2
Let the phone ring 9 times.
R A long beep is heard.
3
Enter your remote access code within 10
seconds after the long beep.
R The greeting message is played back.
R You can either hang up, or enter your

Answering system settings

Number of rings before the unit
*1
answers a call
You can change the number of times the
phone rings "Number of Rings" before the
unit answers a call. You can select 2 to 6
rings, or "Auto".
The default setting is "4 Rings".
"Auto": The unit's answering system answers
at the end of the 2nd ring when new
messages have been recorded, or at the end
of the 5th ring when there are no new
messages. If you call your phone from outside
to listen to new messages (page 42), you
know that there are no new messages when
42
Operation
Erase all messages
Reset to a pre-recorded
greeting message (during
greeting message playback)
End remote operation
(or hang up)
remote access code again and begin
remote operation (page 41).
2013/02/15 18:28:13