Registering A Unit - Panasonic KX-TG7851FX Operating Instructions Manual

Programming
– Caller list
– Voice mail messages
– Call restrict
R The following items will be retained:
– Display language
– Date and time
– Handset name
– Repeater mode
– Recordings, including your greeting
message and caller messages
(KX-TG7861 series: page 3)
– Call screening (KX-TG7861 series:
page 3)
– Call barred list
– Shared phonebook
R If you select the desired country in step 2,
the following default settings will be
changed for the selected country's default
settings:
– Recall/flash time (page 26)
– Message centre 1 and 2 (page 24)
– SMS on/off (page 24)
R According to your country selection in step
2, the answering system announcement
language changes as follows (KX-TG7861
series: page 3):
– "Other" = English
– "Česká rep." = Czech
– "Slovensko" = Slovak
R After changing the unit's region setting/
resetting the base unit,
displayed on the handset momentarily. This
is normal and the handset can be used
once is displayed.

Registering a unit

Operating additional units
Additional handsets
Up to 6 handsets can be registered to the
base unit.
Important:
R The additional handset model
recommended for use with this unit is noted
on page 5. If another handset model is
used, certain operations may not be
available.
32
TG7851_61FX(en)_0215_ver011.pdf
Registering a handset to the
base unit
The supplied handset and base unit are
pre-registered. If for some reason the handset
is not registered to the base unit (for example,
is displayed even when the handset is
near the base unit), re-register the handset.
1
Handset:
M
2
Base unit:
Proceed with the operation for your model.
n KX-TG7851 series: page 3
n KX-TG7861 series: page 3
R If all registered handsets start ringing,
R The next step must be completed
3
Handset:
MOKN a Wait until "Base PIN" is
displayed. a Enter the base unit PIN
(default: "0000"). a MOKN
may be
R If you forget your PIN, contact an
R When the handset has been registered
Note:
R While registering, "Base in
registering" is displayed on all
registered handsets.
R When you purchase an additional handset,
refer to the additional handset's installation
manual for registration.
Deregistering a handset
A handset can cancel its own registration to
the base unit, or other handsets registered to
the same base unit. This allows the handset to
end its wireless connection with the system.
32
N (right soft key) #130
Press and hold M N for about 5
seconds. (No registration tone)
Press and hold M N for about 5
seconds, until the registration tone
sounds.
press M N again to stop, then repeat
this step.
within 90 seconds.
authorised service centre.
successfully, is displayed.
2013/02/15 18:28:13