Kenmore 73511 Owner's Manual page 41

The ProbUem So ver Icont ouedl
PROBLEM POSSIBLE CAUSE AND/OR WHAT TO DO
SURFACE LIGHT o Fluorescent lamp is loose or defective,, Adjust or replace
DOES NOT WORK o Switch operating tight is broken. Call for service.
STRONG ODOR - Improper air/gas ratio in oven. Adjust oven burner air shutters.
o An odor from the insulation around the oven liner is normal for the first few
times oven is used. This is temporary.
OVEN WILL NOT • Oven temperature is too high to set self-cleaning operation., Allow the range to
SELF-CLEAN cool to room temperature and reset the controls,
• Door latch handle not moved all the way to the right.
OVEN DOOR WILL o Oven must cool below locking temperature (approximately 30 minutes after the
NOT UNLOCK clean cycle is complete).
OVEN NOT CLEAN o Oven controls not set properly. Review pages 29 and 31.
AFTER CLEAN
CYCLE o Heavily soiled ovens require 3'A to 4-hour Clean Time,,
o Heavy spillovers should be cleaned up before starting clean cycle,,
"door" APPEARS • Self-cleaning cycle has been selected but latch handle was not moved all the
ON DISPLAY way to the right,, Move latch handle.
o Latch handle was moved to the right but another program other than self-
cleaning was selected° Move latch handle to the right only when setting self-
cleaning cycle.
CONTROL BEEPS • This is reminding you to enter a bake temperature, (See Steps 7 and 8 on
AFTER ENTERING page 23)
OVEN TtME OR
STOP TIME
"F-" AND A NUMBER ° This is the function error code,, if function error code appears during the self-
FLASH ON DISPLAY cleaning function, check oven door latch--the latch handle may have been
moved, even if only slightly, from the latched position. Make sure latch is moved
to the right as far as it will go. Touch CLEAR/OFF pad. If function error code
does not clear, unplug the range and then plug it back in. If function error still
appears, unplug the range and call for service.
4O