Kenmore 73511 Owner's Manual page 35

Care and Cleaning/continued/
Oven Lamp Replacement
CAUTION: Before replacing your oven bulb, dis-
connect electrical power to the range at the main
fuse or circuit breaker panel. Be sure to let the
lamp cover and bulb coo! completely,
The oven lamp (bulb) is
covered with a removable
glass cover that is held in
place with a bail-shaped
wire Remove oven door,
if desired, to reach cover
easily,,
To remove:
1, Hold hand under cover so it doesn't fall when
released With fingers of same hand. firmly push back
wire bail until it clears cover, Lift off cover. DO NOT
REMOVE ANY SCREWS TO REMOVE COVER.
2. Replace bulb with a 40-watt household appliance
bulbo
To replace cover:
1. Place it into groove of lamp receptacle. Pull wire bail
forward to center of cover until it snaps into place,
When in place, wire holds cover firmly. Be certain wire
bail is in depression in center of cover
2, Connect electrical power to the range.
Surface Light and Starter
(On models so equipped)
CAUTION: Do not touch the bulb with wet hands
or when bulb is hot, Never wipe the light area with
a wet cloth. Electrical power must be shut off if
you have to replace a bulb.
To replace bulb:
Lift up 1. Flip front of the hinged
canopy up,
2. Remove fluorescent
light bulb Replace the
bulb with one of the same
length and wattage,
3. Lower the canopy.
To replace starter:
1. Open canopy and remove bulb as explained above,,
2. Grasp starter, turn it counterclockwise about one-
quarter turn and lift out. Replace with one of the same
wattage,
3. Reposition bulb and lower the canopy,
34