To Install In Ethernet - Vivotek TC5632 User Manual

The following table lists the LED patterns in general:
Condition
Loading system after power on
During booting procedure
After network is setup (system up)
During the upgrade firmware process
Enable audio

To install in Ethernet

Make sure the Ethernet is firmly connected to a switch hub. After attaching the Ethernet
cable plug in the power adapter. If the LED turns out to be blink green, go to next
paragraph "Software installation". If the Ethernet is not available, Network Camera will
switch to wireless LAN mode.
This Network Camera provides a general I/O terminal block with one digital input and one
digital output device control. The pin definition is as below.
1. Power
2. Digital output
3. Digital input
4. ground
LED color
Steady red
Steady blue and red
Blink green every second
Fast blink red
Slowly blink green
- 7 -
www.vivotek.com
T: 886-2-82455282
F: 886-2-82455532