Software Installation; Initial Access To The Network Camera; Check Network Settings; Add Password To Prevent Unauthorized Access - Vivotek TC5632 User Manual

Software Installation

At the end of the hardware installation, users can use "Installation Wizard 2" program
included in the product CDROM to find the location of the Network Camera. There may be
many Network Cameras in the local network. Users can differentiate the Network
Cameras with the serial number. The serial number is printed on the labels on the carton
and the back of the Network Camera body. Please refer to the user's manual of
Installation Wizard 2 for details.

Initial Access to the Network Camera

Check Network Settings

The Network Camera can be connected either before or immediately after software
installation onto the Local Area Network. The Administrator should complete the
network settings on the configuration page, including the correct subnet mask and IP
address of gateway and DNS. Ask your network administrator or Internet service
provider for the detail information. By default the Network Camera requires the
Administrator to run installation every time it reboots. If the network settings are to
remain unchanged, disable the Install option. Refer to "Network settings" on the
System Configuration page for details. If any setting is entered incorrectly and
cannot proceed to setting up the Network Camera, restore the factory settings
following the steps in the "Troubleshooting" chapter of the Appendix.

Add Password to Prevent Unauthorized Access

The default Administrator's password is blank and the Network Camera initially will
not ask for any password. The Administrator should immediately implement a new
password as a matter of prudent security practice. Once the Administrator's
password is saved, the Network Camera will ask for the user's name and password
- 8 -
www.vivotek.com
T: 886-2-82455282
F: 886-2-82455532