Connecting Usb Powered Devices - DigiPos PH-6000B User Manual

Connecting USB Powered Devices

The DigiPoS PH-6000B provides a wide range of output voltages from its PoweredUSB
ports: 5V, 12V, and 24V. These ports allow the connected devices to be powered directly
from your DigiPoS PH-6000B. You can also use these ports for standard USB data
transmission.
Note: To find out the required voltage of the USB peripheral device to be connected,
please refer to the device's manual or contact your peripheral device dealer.
Using the 5V PoweredUSB port
The 5V PoweredUSB port (black or orange
connector) is located on the front of your DigiPoS
PH-6000B. This port allows you to connect a low
power device, such as a CCD barcode scanner.
Using the 12V PoweredUSB port
The 12V PoweredUSB port (blue connector) is
located on the rear side of your DigiPoS PH-
6000B. By using the 12V PoweredUSB port, you
can connect equipment, such as VFDs (Vacuum
Fluorescent Display) and customer displays,
powered by a 12V current.
Connect one end of the 12V USB powered cable
to the 12V PoweredUSB port (blue connector) on
the DigiPoS PH-6000B. Connect the two
connectors at the other end to a 12V device.
Note: A 12V USB powered cable is required for
this connection. If you need to purchase one,
please contact your vendor.
Making Connections
DigiPoS DigiPoS DigiPoS
2
5V
3 1
5V
24V DC
INPUT
24V
12V
+
12V
8