Getting Started; Bracket Setup For Installation; Initial Setting - Samsung SPD-2200 Series Operation Manual

Getting started

Bracket Setup for Installation

AC 24V Output (for Heater connection)
12
SPEED DOME CAMERA
Video Out
Alarm In 1
Alarm In 2
Alarm In 3
Alarm In 4
Alarm Out 1
Alarm Out 2
Mainframe 18PIN Connector

Initial Setting

● Communication Protocol Setting (Installation Bracket)
Select and set SW1 on the installation bracket for setting the communication protocol.
SW1
0
1
2
3
4
5~F
Note) Factory Default : 0 (Samsung, 9600)
● Baud Rate Setting by DVR Model
For control of the speed dome camera using DVR without a dedicated controller, set the baud rate by DVR
model as described below.
Protocol
DVR Model
SVR-430
SVR-900/1620
SVR-1630
Note) A faster rate may degrade stability.
The control function may not be available depending on the DVR Firmware version.
Be sure to install the latest DVR Firmware version.
● Camera ID Setting (Mainframe front panel)
·
Set the Camera ID using the two rotary switches. SW1 and SW2
refer to the lower and upper positions, respectively.
·
EX) If the camera ID is number 1, set as described below.
Protocol Baud Rate (BPS)
Samsung 9,600
Samsung 19,200
Pelco-D 2,400
Pelco-D 4,800
Pelco-D 9,600
Reserve
Samsung
Pelco
9600,19200 9,600
9600,19200 4800, 9600
9600,19200 2400,4800,9600
SW2 SW1
0 1
SW2 SW1
SPEED DOME CAMERA
13