Samsung SPD-2200 Series Operation Manual page 13

How to Install
How to Install the Camera (using the Embedded Housing)
① Make a hole of 155mm in diameter in the ceiling to install the camera. Pull the cable down through it.
② Connect the video cable, controller cable and power adapter cable to the mounting bracket. (See Page 19)
Video connection cable
Power adapter connection cable
③ Fix the mounting bracket to the Embedded housing using three screws.
④ Fasten the eye bolt on the housing and fix the housing to the ceiling, using the cable to prevent it from falling.
⑤ Fix the housing to the ceiling using three screws.
⑥ Connect the Installation bracket to the connector of the speed dome camera.
⑦ Insert the pin at the bottom of the camera into the bracket fixing hole and turn it anticlockwise to secure.
⑧ Fasten the lock screw.
⑨ Place the external cover over the housing and then rotate and fix it.
24
SPEED DOME CAMERA
Controller connection cable
Hole for Fixing the Dome Camera
Installation bracket connector
Camera connector
Screws to prevent the
camera from coming loose.
Cautions
·Check the power adapter input power before connecting the power supply.
·Install the camera using the installation template and cable and fixing screws that are supplied separately for installations
without a housing.
·Note that the locking screws should be fastened. If one of the locking screws is not properly fastened, the camera may fall due
to vibration or impact once it is installed.
Embedded Housing
Ceiling
Installation Bracket
Installation Pin
External Cover (Decoration ring)
25
SPEED DOME CAMERA