Components
Front Panel
Rotary Switch 2 (SW2)
Camera ID address setting
switch.
Rotary Switch 1 (SW1)
Camera ID address setting
switch.
Cautions
·If the Rotary Switch and DIP Switch (SW3) are not displayed, turn the power off and on again. Both switches will then be
displayed.
·Do not pull or hold onto the connector cables when moving or delivering the product. It may cause operational failure.
·See the inside of the door for settings for the switches on the main unit of the product.
10
SPEED DOME CAMERA
Connector Cable
Connect to the bracket
connector for installation.
Power Switch
Power on or off
(※Factory default : OFF)
DIP Switch (SW3)
For setting each function
1. For selecting a controller
2. For factory setting
3. For terminal setting
4. For terminal setting
Back Panel
Protocol Selection Switch
Video Out Terminal
AC 24V Out
Power LED
Power In Terminal
Controller In Terminal
ALARM Out
ALARM In
11
SPEED DOME CAMERA