Attach Handle To Vacuum; Attach Dust Bin To Vacuum; Attach Vacuum Hose And Tools - Samsung DJ68-00450F User Manual

Assembling the cleaner

ATTAcH HANdlE TO VAcUUM

1. Stand the vacuum upright and slide the base of the
handle firmly into the grooves at the top of the
vacuum body.
2. Check to be sure the handle is fitted to the vacuum
body. If there is a gap, continue to push firmly until the
handle is flush.
3. Insert the screw provided from the screw packet into
the existing hole.
Tighten securely with a screwdriver.

ATTAcH dUST bIN TO VAcUUM

Fit the groove located on the lower
front side of the Dust Bin to the hook
located on the vacuum body and
attach the hook located on the
Dust Bin Handle to the vacuum body
as shown.

ATTAcH VAcUUM HOSE ANd TOOlS

1. Attach the Twist Snap Hose by lining up the
taps on the base with the corresponding
notches on the back of the vacuum as shown.
2. Turn the Twist Snap Hose clockwise to lock
the hose into place.
3. Grasping the Hose Wand, slide the end of the
it onto the Hose Wand Base. Snap the Hose
into the Hose Clip.
Note:
The vacuum will not operate effectively
unless the Hose Wand is firmly attached.
4. Attach the Lower Cord Wrap by lining up
the tab on the base with the corresponding
notch on the back of the vacuum and turn it
clockwise as shown.
5. Attach the Extension Wand and the Crevice
Tool together into the holder on the right side
of the body as shown.
6. Attach the Combination Tool into the holder
on the left side of the body as shown.
7. Attach the Bracket Brush on the front of the
handle and clip the Mini Turbo Brush into the
Bracket Brush as shown.
* Select Models Only
assembling the cleaner _5